OneCNCXP 5.44 is released please download

This update adds new methods of setting tool profile offset for the users with older controllers that have difficulty with cutter diameter offset. This now allows for automatic offset by OneCNC with the codes for wear size control assuming zero offset at the control.

The only values for diameter you would use at the control would be the adjustment for diameter wear or spring.

This completes all the additions to this OneCNCXP series.

OneCNCXP 5.43 is released please download.

This update corrects a problem found in certain circumstances in the verification of a full circle movement in 2D graphically due to opengl although the NC code would be correct.

This update now corrects that verification for all graphics cards.

OneCNCXP is shipped with the NC post settings circular movement set to half which verifies correctly and this update is not required for that.

Users setting their NC post setting to full circular movement should check that their machine can handle it correctly to ensure it is the same as the correct verification.

Some machines can have a problem with this due to the fact that the start and end point of the movement is in the same position.

Please download this update.

OneCNCXP 5.42 is released please download.

CAM Inverse Settings:
This update provides for new cam settings for machines that require inverse I and J commands.

Arcs as Lines:
A tolerance has been added for cutting arcs as lines to enable less code for roughing.

Rendering:
The rendering type selection in the rendering window has been modified to prevent scrolling.

Print:
Print setting have now saved so if you always like to print 1:1 this is now saved.

DXF:
Exporting files from OneCNCXP in DXF layer names have been modified to only output alpha and numeric to max 32 char due to the limitations of Autocad DXF.
If you use layer names like 1/2" T1 steel plate this will now read 1_2__T1_steel in Autocad after importing having the / " and spaces replaced with underscores.

Line:
Angle line now has a default of 1 in line length.

Rectangle:
Rectangle drawing has been corrected in adding fillet to the corners of the rectangle.

Contact your sales office for a link to download.