OneCNC Series Updates

This is a history of all OneCNC updates.

You may notice sometimes there can be a jump in version numbers.

This is due to intensive and continual internal testing where we thoroughly test versions before releasing proven functional updates.


To download updates, see our OneCNC Updates page.

OneCNCXR 6.41

Update 6.41 released 26th August 2005

This update only applies to OneCNCXR Lathe

OneCNCXR Lathe Express and Professional IMPORTANT update

There was an adjustment made to the internal threading and internal boring cycle for lathe. This is an important update and should be immediately updated for OneCNCXR Lathe users.

There is no need to download updates for software other than lathe versions because there are no alterations to other versions at this time.

Read More...

OneCNCXR 6.38

Update 6.38 released 19th April 2005

This update only applies to OneCNCXR Lathe and OneCNCXR Profiler

There is no need for updates for other software versions because there are no alterations since 6.36 although all versions now carry the 6.38 version number.

All products other than profiler and lathe are current at version 6.36

OneCNCXR Profiler and OneCNCXR Express IMPORTANT update

There was an adjustment made to the automatic offset function to correct anomalies of imported profiles where the start and end points were not correctly sequenced in the files. OneCNCXR now has automatic logic for correcting this. This is an important update and should be immediately updated for Profiler users.

OneCNCXR Lathe Professional and Express

A minor correction was made to the cycle rough with finish preview to better accurately display only in preview.

Read More...

OneCNCXR 6.36

Update 6.36 released 10th February 2005

Help Files

 

OneCNCXR Lathe Professional and Express

An Important update:

Some adjustments were made to the turn face rough function when using the cycle and cycle finish. This is an important update for lathe users.

OneCNCXR Profiler Professional and Express versions.

An Important update:

An adjustment was made to the kerf applied by the machine controller. Although we realise that most users use the automatic kerf offset whe OneCNC offsets for the kerf automatically but OneCNC has methods for atdding the kerf using the machine control. Th applies the G41 or G42 into the profiles sy that the kerf is applied by a setting at the machine control. This adjustment fixes the situation where the G41/42 was not being output.

Read More...