OneCNCXR3 Tips on using the Interface M5

  Jan 31 2009

There are 2 movies of Tips on using the OneCNCXR3 user interface. Although it is very easy to use the OneCNCXR3 user interface these tips should help you become familiar even sooner than you think.

OneCNCXR3 Tips on the user interface movie (a)

OneCNCXR3 Tips on the user interface movie (b)

Posted Under: Tech Tips: West, VideosLink

OneCNCXR3 Tips on Introduction M15-2

  Jan 31 2009

Here are some tops to get you started using OneCNCXR3.

OneCNCXR3 Introduction tips (a)

OneCNCXR3 Introduction tips (b)

Posted Under: Tech Tips: West, VideosLink

OneCNCXR3 Tips using CAM part 1, 2, 3

  Jan 31 2009

There are 3 separate 2.5 D parts here to set you going with this type of work. These are parts drawn in previous exercises in introduction to CAD geometry.

Here is part 1 (a)

Here is part 1 (b)

Here is part 2 (a)

Here is part 2 (b)

Here is part 3(a)

Here is part 3(b

Posted Under: Tech Tips: West, VideosLink